D-Link DES-1210-28/ME - Config Greeting_Message

DES-1210-28/ME Metro Ethernet Managed Switch CLI Reference Guide
27
config greeting_message
Purpose Used to configure the login banner (greeting message).
Syntax
config greeting_message {default}
Description
The config greeting_message command to modify the login
banner (greeting message).
Parameters
default – If the user enters default to the modify banner command,
then the banner will be reset to the original factory banner.
To open the Banner Editor, click Enter after typing the config
greeting_message command. Type the information to be displayed
on the banner by using the commands described on the Banner
Editor:
Quit without save: Ctrl+C
Save and quit: Ctrl+W
Move cursor: Left/Right/Up/Down
Delete line: Ctrl+D
Erase all setting: Ctrl+X
Reload original setting: Ctrl+L
Restrictions
Only Administrator-level users can issue this command. Other
restrictions include:
If the “reset” command is executed, the modified banner will remain
modified. However, the “reset config/reset system” command will
reset the modified banner to the original factory banner.
The capacity of the banner is 6*80. 6 Lines and 80 characters per
line.
Ctrl+W will only save the modified banner in the DRAM. Users need
to type the “save config/save all” command to save it into Flash.
Only valid in threshold level.
Example usage:
To the banner: