DES-1210-28/ME Metro Ethernet Managed Switch CLI Reference Guide
221
DES-1210-28/ME:5# show radius
Command: show radius
Index Ip Address Auth-Port Acct-Port Timeout Retransmit Key
(secs)
----- ---------------- --------- ---------- --------- --------------- ------
1 10.48.74.121 1812 1813 5 10 dlink
Total Entries : 1
Success!
DES-1210-28/ME:5#
config 802.1x auth_mode
Purpose To configure the 802.1x authentication mode on the Switch.
Syntax
config 802.1x auth_mode [port_based | mac_based]
Description
The config 802.1x auth_mode command enables either the port-
based or MAC-based 802.1x authentication feature on the Switch.
Parameters
[port_based | mac_based] – Specifies whether 802.1x
authentication is by port or MAC address.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To configure 802.1x authentication by port address:
DES-1210-28/ME:5# config 802.1x auth_mode port_based
Command: config 802.1x auth_mode port_based
Success!
DES-1210-28/ME:5#
create 802.1x guest_vlan
Purpose Enables network access to a Guest VLAN.
Syntax
create 802.1x guest vlan <vlan_name 32>
Description
The create 802.1x guest_vlan command enables network access
to a 802.1x Guest VLAN. A network administrator can use 802.1x
Guest VLANs to deny network access via port–based authentication,
but grant Internet access to unauthorized users.
Parameters
<vlan_name 32> − The name of the 802.1x Guest VLAN to be
created.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To create a 802.1x Guest VLAN:
To Next Page
Loading...
