D-Link DES-1210-28/ME - Ssl Commands; Enable Ssl; Disable Ssl

DES-1210-28/ME Metro Ethernet Managed Switch CLI Reference Guide
249
39
3939
39
SSL COMMANDS
The SSL commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command Parameter
enable ssl
disable ssl
show ssl
download ssl certificate
<ipaddr> certfilename <path_filename 64>
Each command is listed in detail, as follows:
enable ssl
Purpose To enable the SSL function on the Switch.
Syntax
enable ssl
Description
The enable ssl command enables SSL on the Switch by
implementing every combination of listed ciphersuites on the Switch.
Entering this command enables the SSL status on the Switch.
Enabling SSL disables the web-manager on the Switch.
Parameters None.
Restrictions Only administrator or operator-level users can issue this command.
Example usage:
To enable SSL on the Switch for all ciphersuites:
DES-1210-28/ME:5# enable ssl
Command: enable ssl
Note: HTTP will be disabled if SSL is enabled.
Success.
DES-1210-28/ME:5#
disable ssl
Purpose To disable the SSL function on the Switch.
Syntax
disable ssl
Description
The disable ssl command disables SSL on the Switch and can be
used to disable all combinations of listed ciphersuites on the Switch.
Note that disabling SSL will not enable WEB access automatically
(WEB access will stay disabled), and you’ll need to enable it
manually.