D-Link DES-1210-28/ME - Ssh Commands; Enable Ssh

DES-1210-28/ME Metro Ethernet Managed Switch CLI Reference Guide
243
38
3838
38
SSH COMMANDS
The SSH commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command Parameter
enable ssh
disable ssh
config ssh algorithm [3DES | MD5 | RSA | SHA1] [disable | enable]
config ssh authmode [publickey | hostbased | password] [enable | disable]
show ssh authmode
config ssh server
[authfail <int 2-20> | contimeout <sec 120-600> | maxsession <int 1-4> | rekey
[10min | 30min | 60min | never]]
show ssh server
show ssh algorithm
config ssh user
<string 15> authmode [hostbased hostname <domain_name> hostname_IP
<ipaddr> | password | publickey]
show ssh user
authmode
Each command is listed in detail, as follows:
enable ssh
Purpose To enable SSH.
Syntax
enable ssh
Description
The enable ssh command enables SSH on the Switch.
Parameters None
Restrictions Only administrator or operator-level users can issue this command.
Example usage:
To enable SSH: