D-Link DES-1210-28/ME - Show 802.1 X; Config 802.1 X Feap; Show 802.1 X Auth_State

DES-1210-28/ME Metro Ethernet Managed Switch CLI Reference Guide
213
show 802.1x
Purpose To display the 802.1x server information on the Switch.
Syntax
show 802.1x
Description
The show 802.1x command displays the 802.1x Port-based
Network Access control server application on the Switch.
Parameters None.
Restrictions None.
Example usage:
To display 802.1x on the Switch:
DES-1210-28/ME:5# show 802.1x
Command: show 802.1x
802.1X : Enable
Authentication Mode : Port_base
Authentication Method : Local
Success!
DES-1210-28/ME:5#
config 802.1x feap
Purpose To configure the 802.1x feap on the Switch.
Syntax
config 802.1x feap [enable | disable]
Description
The config 802.1x command configure the 802.1x feap on the
Switch.
Parameters
[enable | disable] − enables or disables the 802.1x feap on the
switch.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To configure 802.1x feap on the Switch:
DES-1210-28/ME:5# config 802.1x feap enable
Command: config 802.1x feap enable
Success.
DES-1210-28/ME:5#
show 802.1x auth_state
Purpose To display the current authentication state of the 802.1x server on the
Switch.
Syntax
show 802.1x auth_state {ports <portlist>}
Description
The show 802.1x auth_state command displays the current 802.1x
authentication state of the specified ports of the Port-based Network
Access Control server application on the Switch.
The following details are displayed: