D-Link DES-1210-28/ME - Smtp Sent_Testmsg

DES-1210-28/ME Metro Ethernet Managed Switch CLI Reference Guide
25
Restrictions None.
Example usage:
To display SMTP information on the Switch:
DES-1210-28/ME:5# show smtp
Command: show smtp
smtp status : Enable
smtp server address : 0.0.0.0
smtp server port : 25
self mail address : dlink@mail.com.tw
Index Mail Receiver Address
-------- --------------------------------------
1
2
3
4
5
6
7
8
DES-1210-28/ME:5#
smtp sent_testmsg
Purpose To send test messages to all mail recipients configured on the
Switch.
Syntax
smtp sent_testmsg
Description
The smtp sent_testmsg command is used to send test messages
to all mail recipients configured on the Switch.
Parameters None.
Restrictions Only Administrator-level users can issue this command..
Example usage:
To send SMTP test message to all mail receivers:
DES-1210-28/ME:5# smtp sent_testmsg
Command: smtp sent_testmsg
Subject: This is a SMTP test
Content: Hello everybody!!
Sending mail, please wait...
Success!
DES-1210-28/ME:5#