D-Link DES-1210-28/ME - Enable SNMP Support

DES-1210-28/ME Metro Ethernet Managed Switch CLI Reference Guide
57
Total Entries: 2
DES-1210-28/ME:5#
create snmp community
Purpose To create an SNMP community string to define the relationship
between the SNMP manager and an SNMP agent.
Syntax
create snmp community <community_string 32> <username
32>
Description
The create snmp community command creates an SNMP
community string and assigns access-limiting characteristics to this
community string. The community string acts like a password to
permit access to the agent on the Switch. One or more of the
following characteristics can be associated with the community
string:
An Access List of IP addresses of SNMP managers that are
permitted to use the community string to gain access to the Switch’s
SNMP agent.
An MIB view that defines the subset of all MIB objects to be
accessible to the SNMP community.
Read/write or read-only level permission for the MIB objects
accessible to the SNMP community.
Parameters
<community_string 32> − A string of up to 32 alphanumeric
characters that is used to identify members of an SNMP community.
This string is used like a password to give remote SNMP managers
access to MIB objects in the Switch’s SNMP agent.
<username 32> − A string of up to 32 alphanumeric characters that
is used to identify the group of MIB objects that a remote SNMP
manager is allowed to access on the Switch.
Restrictions Only administrator or operate-level users can issue this command.
Example usage:
To create the SNMP community string ‘dlink:’
DES-1210-28/ME:5# create snmp community dlinkgroup dlink
Success.
DES-1210-28/ME:5#
delete snmp community
Purpose To remove a specific SNMP community string from the Switch.
Syntax
delete snmp community <community_string 32>
Description
The delete snmp community command removes a previously
defined SNMP community string from the Switch.
Parameters
<community_string 32> − A string of up to 32 alphanumeric
characters that is used to identify members of an SNMP community
to delete. This string is used like a password to give remote SNMP
managers access to MIB objects in the Switch’s SNMP agent.