D-Link DES-1210-28/ME - Basic IP Commands; Configure System IP Interface

DES-1210-28/ME Metro Ethernet Managed Switch CLI Reference Guide
167
config vlan_trunk ports
Purpose To configure VLAN Trunking port settings on the Switch.
Syntax
config vlan_trunk ports [<portlist> | all] state [enable | disable]
Description
The config vlan_trunk ports command configures the VLAN
trunking port settings on the Switch. The user can enable VLAN
Trunking and define ports to be added to the VLAN Trunking
settings.
Parameters
[<portlist> | all] − A port, range of ports or all ports for which to
configure VLAN Trunking.
state [enable | disable] − enable and disable VLAN trunking.
Restrictions Only administrator or operator-level users can issue this command.
Example usage:
To define VLAN Trunking:
DES-1210-28/ME:5# config vlan_trunk ports all state enable
Command: config vlan_trunk ports all state enable
success
DES-1210-28/ME:5#
enable asymmetric_vlan
Purpose To enable Asymmetric VLAN on the switch.
Syntax
enable asymmetric_vlan
Description
The enable asymmetric_vlan command, along with the disable
enable asymmetric_vlan command below, is used to enable and
disable Asymmetric VLAN on the Switch
Parameters None.
Restrictions Only administrator or operator-level users can issue this command.
Example usage:
To enable Asymettric VLAN on the switch:
DES-1210-28/ME:5# enable asymmetric_vlan
Command: enable asymmetric_vlan
Success
DES-1210-28/ME:5#
disable asymmetric_vlan
Purpose To disable Asymmetric VLAN on the switch.
Syntax
disable asymmetric_vlan
Description
The disable asymmetric_vlan command, along with the enable
asymmetric_vlan command below, is used to disable and enable
Asymmetric VLAN on the Switch.
Parameters None.
Restrictions Only administrator or operator-level users can issue this command.