D-Link DES-1210-28/ME - Show Snmp Community; Config Snmp Engineid

DES-1210-28/ME Metro Ethernet Managed Switch CLI Reference Guide
58
Restrictions Only administrator or operate-level users can issue this command.
Example usage:
To delete the SNMP community string ‘dlink’:
DES-1210-28/ME:5# delete snmp community dlink
Command: delete snmp community dlink
Success!
DES-1210-28/ME:5#
show snmp community
Purpose To display SNMP community strings configured on the Switch.
Syntax
show snmp community {<community_string 32>}
Description
The show snmp community command displays SNMP community
strings that are configured on the Switch.
Parameters
<community_string 32> − A string of up to 20 alphanumeric
characters that is used to identify members of an SNMP community.
This string is used like a password to give remote SNMP managers
access to MIB objects in the Switch’s SNMP agent.
Restrictions None.
Example usage:
To display the currently entered SNMP community strings:
DES-1210-28/ME:5# show snmp community
Command: show snmp community
SNMP Community Table
(Maximum Entries : 10)
Community Name User Name
------------------ ------------
public ReadOnly
private ReadWrite
Total Entries: 2
DES-1210-28/ME:5#
config snmp engineID
Purpose To configure a name for the SNMP engine on the Switch.
Syntax
config snmp engineID <snmp_engineID 64>
Description
The config snmp engineID command configures a name for the
SNMP engine on the Switch.
Parameters
<snmp_engineID 64> − A string, of between 10 and 64