D-Link DES-1210-28/ME - Config Radius Delete; Config Radius

DES-1210-28/ME Metro Ethernet Managed Switch CLI Reference Guide
219
32>] {default | auth_port <udp_port_number 1-65535> |
acct_port <udp_port_number 1-65535>}
Description
The config radius add command configures the settings the Switch
uses to communicate with a RADIUS server.
Parameters
<server_index 1-3> – The index of the RADIUS server.
<server_ip> – The IP address of the RADIUS server.
key – Specifies that a password and encryption key are to be used
between the Switch and the RADIUS server.
<passwd 32> – The shared-secret key used by the RADIUS server
and the Switch. Up to 128 characters can be used.
default – Uses the default udp port number in both the auth_port and
acct_port settings.
auth_port <udp_port_number 1-65535> – The UDP port number for
authentication requests. The default is 1812.
acct_port <udp_port_number 1-65535> – The UDP port number for
accounting requests. The default is 1813.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To configure the RADIUS server communication settings:
DES-1210-28/ME:5# config radius add 1 10.48.74.121 key dlink default
Command: config radius add 1 10.48.74.121 key dlink default
Success!
DES-1210-28/ME:5#
config radius delete
Purpose To delete a previously entered RADIUS server configuration.
Syntax
config radius delete <server_index 1-3>
Description
The config radius delete command deletes a previously entered
RADIUS server configuration.
Parameters
<server_index 1-3> – The index of the RADIUS server.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To delete previously configured RADIUS server communication settings:
DES-1210-28/ME:5# config radius delete 1
Command: config radius delete 1
Success!
DES-1210-28/ME:5# #
config radius
Purpose To configure the Switch’s RADIUS settings.
Syntax
config radius <server_index 1-3> { key <passwd 32> | auth_port
<udp_port_number 1-65535> | acct_port <udp_port_number 1-