D-Link DES-1210-28/ME - Show Snmp Engineid; Create Snmp Group

DES-1210-28/ME Metro Ethernet Managed Switch CLI Reference Guide
59
alphanumeric characters, to be used to identify the SNMP engine on
the Switch.
Restrictions Only administrator or operate-level users can issue this command.
Example usage:
To give the SNMP agent on the Switch:
DES-1210-28/ME:5# config snmp engineID 12345678900
Command: config snmp engineID 12345678900
Success!
DES-1210-28/ME:5#
show snmp engineID
Purpose To display the identification of the SNMP engine on the Switch.
Syntax
show snmp engineID
Description
The show snmp engineID command displays the identification of
the SNMP engine on the Switch.
Parameters None.
Restrictions None.
Example usage:
To display the current name of the SNMP engine on the Switch:
DES-1210-28/ME:5# show snmp engineID
Command: show snmp engineID
Default SNMP Engine ID : 4445532d313231
SNMP Engine ID : 012345678900
DES-1210-28/ME:5#
create snmp group
Purpose To create a new SNMP group, or a table that maps SNMP users to
SNMP views.
Syntax
create snmp group <groupname 32> [v1 | v2c | v3
[noauth_nopriv | auth_nopriv | auth_priv]{notify_view
<view_name 32>}] {read_view <view_name 32> | write_view
<view_name 32>}
Description
The create snmp group command creates a new SNMP group, or
a table that maps SNMP users to SNMP views.
Parameters
<groupname 32> − A name of up to 30 alphanumeric characters that
identifies the SNMP group the new SNMP user is to be associated
with.
v1 – Specifies that SNMP version 1 is to be used. The Simple
Network Management Protocol (SNMP), version 1, is a network
management protocol that provides a means to monitor and control