DES-1210-28/ME Metro Ethernet Managed Switch CLI Reference Guide
12
password. Up to 31 accounts can be created. You can enter
username and Enter. In this case, the system prompts for the
account’s password, which may be between 0 and 15 characters.
Alternatively, you can enter the username and password on the
same line.
Parameters
admin − Name of the administrator account.
oper − Specify an operator level account.
user − Specify a user account with read-only permissions.
<username 1-15> − The account username may be between 1 and
15 characters.
password <password_string> {encrypted} - the account password
can be included, and (optionally) can be encrypted.
Restrictions Only Administrator level users can issue this command.
Usernames can be between 1 and 15 characters.
Passwords can be between 0 and 15 characters.
NOTE: You are not required to enter a User Name. However, if you do not enter a User Name,
you cannot perform the following actions:
Create a monitor or operator (level 1 or level 14) users until an administrator user (level 15) is
defined.
Delete the last administrator user if there are monitor and/or operator users defined.
Example usage:
To create an administrator-level user account with the username ‘dlink’:
DES-1210-28/ME:5# create account admin dlink
Command: create account admin dlink
Enter a case-sensitive new password:*****
Enter the new password again for confirmation:*****
Success.
DES-1210-28/ME:5#
config account
Purpose To change the password for an existing user account.
Syntax
config account <username 15>
Description
The config account command changes the password for a user
account that has been created using the create account command.
The system prompts for the account’s new password, which may be
between 0 and 15 characters.
Parameters
<username 1-15> − the account username.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To configure the user password of ‘dlink’ account:
To Next Page
Loading...
