D-Link DES-1210-28/ME - Enable Web Management

DES-1210-28/ME Metro Ethernet Managed Switch CLI Reference Guide
15
DES-1210-28/ME:5# show switch
Command: show switch
System name :
System Contact :
System Location :
System up time : 0 days, 1 hrs, 17 min, 19 secs
System Time : 01/01/2011 01:17:20
System hardware version :
System firmware version : 6.00.004
System boot version : 1.00.002
System Protocol version : 2.001.004
System serial number : 1MB1733K0000A
MAC Address : 00-B2-FD-DA-EE-EB
STP : Disabled
SNMP Status : Enabled
Port Mirroring : Disabled
802.1X Status : Disabled
Storm Control : Disabled
802.1Q Management VLAN : Disabled
Safeguard Engine : Enabled
IGMP Snooping : Disabled
DES-1210-28/ME:5#
enable web
Purpose To enable the HTTP-based management software on the Switch.
Syntax
enable web <tcp_port_number 1-65535>
Description
The enable web command enables the Web-based management
software on the Switch. The user can specify the TCP port number
the Switch uses to listen for Telnet requests.
Parameters
<tcp_port_number 1-65535> − The TCP port number. TCP ports are
numbered between 1 and 65535. The ‘well-known’ port for the Web-
based management software is 80.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To enable HTTP and configure the TCP port number to listen for Telnet requests:
DES-1210-28/ME:5# enable web 80
Command: enable web 80
Success.
DES-1210-28/ME:5#