D-Link DES-1210-28/ME - Igmp Snooping Commands

DES-1210-28/ME Metro Ethernet Managed Switch CLI Reference Guide
190
30
3030
30
IGMP SNOOPING COMMANDS
The IGMP Snooping commands in the Command Line Interface (CLI) are listed (along with the
appropriate parameters) in the following table.
Command Parameter
config igmp_snooping
[vlan_name <string 20> | vlanid <vidlist> | all] [host_timeout <sec 130-153025> |
router_timeout <sec 60-600> | leave_timer <sec 1-25> | fast_leave [enable |
disable] | state [enable | disable]]
config igmp_snooping
querier
[vlan_name <string 20> | vlanid <vidlist> | all] state [enable | disable]
{querier_version [IGMPv2 | IGMPv3]}
config igmp_snooping
querier_selection
[vlan_name <string 20> | vlanid <vidlist> | all] state [enable | disable]
config igmp_snooping
querier_interval
<integer 60-600>
config igmp_snooping
robustness_variable
<integer 2-255>
create igmp_snooping
multicast_vlan
<vlan_name 32> <vlanid 2-4094>
config igmp_snooping
multicast_vlan
<vlan_name 32> [add | delete] [member_port <portlist> | source_port <portlist> |
tag_member_port <portlist>] state [enable | disable] {replace_source_ip [none |
<ipaddr>]}
delete igmp_snooping
multicast_vlan
<string 32>
config igmp_snooping
multicast_vlan_group
<vlan_name 32> [add | delete] <ipaddr>
config igmp_snooping
data_driven_learning
[all | vlan_name <string 20> | vlanid <vidlist>] [enable | disable] {aged_out}
config igmp_snooping
data_driven_learning
max_learned_entry <integer 1-256>
clear igmp_snooping
data_driven_group
[all | vlan_name <vlan_name 20> | vlanid <integer 1-4094>] [all | MCGroupAddr
<ipaddr>]
config igmp_snooping
max_response_time
<integer 10-25>
config router_ports [vlan_name <string 20> | vlanid <vidlist> | all] [add | delete] <portlist>
config router_port
s_forbidden
[vlan_name <string 20> | vlanid <vidlist> | all] [add | delete] <portlist>
config igmp
access_authentication
ports
[<portlist> | all] state [enable | disable]
show igmp
access_authentication
ports
[<portlist> | all]