D-Link DES-1210-28/ME - Show Radius

DES-1210-28/ME Metro Ethernet Managed Switch CLI Reference Guide
220
65535> | ipaddress <server_ip> | retransmit <int 1-255> |
timeout <int 1-255>}
Description
The config radius command configures the Switch’s RADIUS
settings.
Parameters
<server_index 1-3> – The index of the RADIUS server.
key – Specifies that a password and encryption key are to be used
between the Switch and the RADIUS server.
• <passwd 32> – The shared-secret key used by the
RADIUS server and the Switch. Up to 128 characters can
be used.
auth_port <udp_port_number 1-65535> – The UDP port number for
authentication requests. The default is 1812.
acct_port <udp_port_number 1-65535> – The UDP port number for
accounting requests. The default is 1813.
ipaddress <server_ip> – The IP address of the RADIUS server.
retransmit <int 1-255> –The number of times the device resends an
authentication request when the server does not respond. The value
is between 1 and 255.
timeout <int 1-255> –Specifies the connection timeout. The value
may be between 1 and 255 seconds.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To configure the RADIUS settings:
DES-1210-28/ME:5# config radius 1 key dlink retransmit 10
Command: config radius 1 key dlink retransmit 10
Success!
DES-1210-28/ME:5#
show radius
Purpose To display the current RADIUS configurations on the Switch.
Syntax
show radius
Description
The show radius command displays the current RADIUS
configurations on the Switch.
Parameters None.
Restrictions None.
Example usage:
To display RADIUS settings on the Switch: