D-Link DES-1210-28/ME - Show Lldp Mgt_Addr; Show Lldp Statistics

DES-1210-28/ME Metro Ethernet Managed Switch CLI Reference Guide
283
DES-1210-28/ME:5# config lldp ports all dot1_tlv_vlan_name vlanid 1 disable
Command: config lldp ports all dot1_tlv_vlan_name vlanid 1 disable
Success!
DES-1210-28/ME:5#
show lldp mgt_addr
Purpose
To display the Link Layer Discovery Protocol (LLDP) configuration
that is advertised from a specific port.
Syntax
show lldp mgt_addr {ipv4 <ipaddr>}
Description
The show lldp mgt_addr command displays the information
regarding the ipv4 address.
Parameters
ipv4 <ipaddr> –Specifies the lldp ipv4 address to be displayed.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To show the LLDP management address advertisement:
DES-1210-28/ME:5# show lldp mgt_addr
Command: show lldp mgt_addr
Total Address : 0
DES-1210-28/ME:5#
show lldp statistics
Purpose
To display the Link Layer Discovery Protocol (LLDP) statistics for the
specified ports.
Syntax
show lldp statistics {ports <portlist>}
Description
The show lldp statistics command displays the statistics of LLDP
on the Switch.
Parameters
{ports <portlist> – Specifies the ports to be displayed.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To show the LLDP statistics for port 15: