D-Link DES-1210-28/ME - Create Access Profile

DES-1210-28/ME Metro Ethernet Managed Switch CLI Reference Guide
274
Description
The enable lldp command enables the Link Layer Discovery
Protocol (LLDP) on the switch.
Parameters None
Restrictions Only Administrator or operator–level users can issue this command.
Example usage:
To enable LLDP on the switch:
DES-1210-28/ME:5# enable lldp
Command: enable lldp
Success!
DES-1210-28/ME:5#
disable lldp
Purpose To disable LLDP on the switch.
Syntax
disable lldp
Description
The disable lldp command disables the Link Discovery Protocol
(LLDP) on the switch.
Parameters None
Restrictions Only Administrator or operator–level users can issue this command.
Example usage:
To disable LLDP on the switch:
DES-1210-28/ME:5# disable lldp
Command: disable lldp
Success!
DES-1210-28/ME:5#
config lldp message_tx_interval
Purpose To define the lldp message tx interval
Syntax
config lldp message_tx_interval <sec 5-32768>
Description
The config lldp message_tx_interval defines the lldp message
interval of the incoming messages.
Parameters
<sec 5-32768> – Defines the message interval time. The range is
between 5 and 32768.
Restrictions Only Administrator or operator–level users can issue this command.
Example usage:
To configure LLDP message tx interval on the switch: