D-Link DES-1210-28/ME - Create Trusted Host

DES-1210-28/ME Metro Ethernet Managed Switch CLI Reference Guide
53
Command Parameter
disable snmp LBD traps
enable snmp
port_security_violation
traps
disable snmp
port_security_violation
traps
enable snmp
rstpport_state_change
traps
disable snmp
rstpport_state_change
traps
enable snmp
system_device_bootup
traps
disable snmp
system_device_bootup
traps
enable snmp
twistedpair_port_link
traps
disable snmp
twistedpair_port_link
traps
enable snmp
duplicate_IP_detected
traps
disable snmp
duplicate_IP_detected
traps
Each command is listed in detail, as follows:
create snmp user
Purpose To create a new SNMP user and add the user to an SNMP group.
Syntax
create snmp user <username 32> <groupname 32> [v1 | v2c | v3
[MD5 <auth_password 32> | SHA <auth_password 32> | none ]
[DES <priv_password 32> | none]]
Description
The create snmp user command creates a new SNMP user and
adds the user to an existing SNMP group.
Parameters
<username 32> − The new SNMP username, up to 32 alphanumeric
characters.
<groupname 32> − The SNMP groupname the new SNMP user is
associated with, up to 32 alphanumeric characters.
auth - The user may also choose the type of authentication