D-Link DES-1210-28/ME - Config Stp Version; Config Stp Fbpdu

DES-1210-28/ME Metro Ethernet Managed Switch CLI Reference Guide
109
DES-1210-28/ME:5# config stp ports 1-3 externalcost 19 state enable
Command: config stp ports 1-3 externalcost 19 state enable
Success.
DES-1210-28/ME:5#
config stp version
Purpose To globally set the version of STP on the Switch.
Syntax
config stp version [mstp | rstp | stp]
Description
The config stp version command sets the version of the spanning
tree to be implemented on the Switch.
Parameters
mstp – Sets the Multiple Spanning Tree Protocol (MSTP) globally on
the Switch.
rstp – Sets the Rapid Spanning Tree Protocol (RSTP) globally on
the Switch.
stp – Sets the Spanning Tree Protocol (STP) globally on the Switch.
Restrictions Only administrator or operator-level users can issue this command.
Example usage:
To set the Switch globally for the Multiple Spanning Tree Protocol (MSTP):
DES-1210-28/ME:5# config stp version mstp
Command: config stp version mstp
Success.
DES-1210-28/ME:5#
config stp fbpdu
Purpose To globally set the fbpdu of STP on the Switch.
Syntax
config stp fbpdu [enable | disable]
Description
The config stp fbpdu command allows the forwarding of STP
BPDU packets from other network devices when STP is disabled on
the Switch.
Parameters None.
Restrictions Only administrator or operator-level users can issue this command.
Example usage:
To set the Switch globally for the Spanning Tree Protocol (STP) fbpdu enable:
DES-1210-28/ME:5# config stp fbpdu enable
Command: config stp fbpdu enable
Success.
DES-1210-28/ME:5#