D-Link DES-1210-28/ME - Port Security Commands; Configure Port Security

DES-1210-28/ME Metro Ethernet Managed Switch CLI Reference Guide
214
Port number − Shows the physical port number on the Switch.
Auth PAE State: Initialize / Disconnected / Connecting / Authenticating
/ Authenticated / Held / ForceAuth / ForceUnauth − Shows the current
state of the Authenticator PAE.
Backend State: Request / Response / Fail / Idle / Initialize / Success /
Timeout − Shows the current state of the Backend Authenticator.
Port Status: Authorized / Unauthorized − Shows the result of the
authentication process. Authorized means that the user was
authenticated, and can access the network. Unauthorized means that
the user was not authenticated, and cannot access the network.
Parameters
ports <portlist> − A port or range of ports whose settings are to be
displayed.
Restrictions None.
Example usage:
To display the 802.1x authentication states for port 1~5 (stacking disabled) for Port-based 802.1x:
DES-1210-28/ME:5# show 802.1x auth_state ports 1-5
Command: show 802.1x auth_state ports 1-5
Port Auth PAE State Backend State Port Status
------ ---------------------- -------------------- ---------------
1 ForceAuth Success Authorized
2 ForceAuth Success Authorized
3 ForceAuth Success Authorized
4 ForceAuth Success Authorized
5 ForceAuth Success Authorized
DES-1210-28/ME:5#
show 802.1x feap status
Purpose To display the current feap states of the 802.1x on the Switch.
Syntax
show 802.1x feap status
Description
The show 802.1x feap status command displays the current 802.1x
feap status on the Switch.
Parameters None.
Restrictions None.
Example usage:
To display the 802.1x feap states:
DES-1210-28/ME:5# show 802.1x feap status
Command: show 802.1x feap status
PNAC control packet (eap) is forwarding....
Success!
DES-1210-28/ME:5#