D-Link DES-1210-28/ME - Show Syslog; Create Syslog Host

DES-1210-28/ME Metro Ethernet Managed Switch CLI Reference Guide
99
Command: disable syslog
Success!
DES-1210-28/ME:5#
show syslog
Purpose To display the syslog protocol status.
Syntax
show syslog
Description
The show syslog command displays the syslog status (enabled or
disabled).
Parameters None.
Restrictions None.
Example usage:
To display the current status of the syslog function:
DES-1210-28/ME:5# show syslog
Command: show syslog
Syslog Global State: Enabled
DES-1210-28/ME:5#
create syslog host
Purpose To create a new syslog host.
Syntax
create syslog host <index 1-4> ipaddress <ipaddr> {severity
[informational | warning | all] | facility [local0 | local1| local2 |
local3 | local4 | local5 | local6 | local7] | udp_port
<udp_port_number>}
Description
The create syslog host command creates a new syslog host.
Parameters
all − Specifies that the command is to be applied to all hosts.
<index 1-4> − The syslog host index id. There are four available
indices, numbered 1 to 4.
ipaddress <ipaddr> − The IP address of the remote host to which
syslog messages are to be sent.
severity − The message severity level indicator. These are
described in the table below (Bold font indicates that the
corresponding severity level is currently supported on the Switch):
Numerical Severity
Code
0 Emergency: system is unusable
1 Alert: action must be taken immediately
2 Critical: critical conditions
3 Error: error conditions