D-Link DES-1210-28/ME - Config Cos Mapping; Show Cos Mapping

DES-1210-28/ME Metro Ethernet Managed Switch CLI Reference Guide
136
Example usage:
To delete the CoS ip mapping on the Switch:
DES-1210-28/ME:5# delete cos ip_mapping destination_ip 10.0.0.56
Command: delete cos ip_mapping destination_ip 10.0.0.56
Success!
DES-1210-28/ME:5#
config cos mapping
Purpose To configure the method of which incoming packets will be identified
for the CoS to port mapping feature.
Syntax
config cos mapping port [<portlist> | all] [802.1p | dscp_tos |
none]
Description
The config cos mapping port command is used to configure the
method of which incoming packets will be identified for the CoS to
port mapping feature on the Switch.
Parameters
<portlist> - A port or range of ports to be configured.
all - Specifies all ports to be configured on the Switch.
[802.1p | dscp | none] – Specified which incoming packets will be
identified for the CoS.
Restrictions Only administrator or operator-level users can issue this command.
Example usage:
To configure the CoS mapping on the Switch:
DES-1210-28/ME:5# config cos mapping port all 802.1p
Command: config cos mapping port all 802.1p
Success
DES-1210-28/ME:5#
show cos mapping
Purpose To display the information regarding CoS mapping enabled ports
and their mapping method.
Syntax
show cos mapping {port <portlist>}
Description
The show cos mapping command displays the information
regarding CoS mapping enabled ports and their mapping method.
Parameters
<portlist> - A port or range of ports to be displayed.
Restrictions None.
Example usage:
To display the CoS mapping on the Switch:
DES-1210-28/ME:5# show cos mapping port 1-5