D-Link DES-1210-28/ME - Disable Snmp Rstpport_State_Change Traps; Enable Snmp System_Device_Bootup Traps; Disable Snmp System_Device_Bootup Traps

DES-1210-28/ME Metro Ethernet Managed Switch CLI Reference Guide
76
disable snmp rstpport_state_change traps
Purpose To disable SNMP RSTP port state change traps.
Syntax
disable snmp rstpport_state_change traps
Description
The disable snmp rstpport_state_change traps command
disables SNMP RSTP port state change traps on the Switch.
Parameters None.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To disable SNMP RSTP port state change traps support on the Switch:
DES-1210-28/ME:5# disable snmp rstpport_state_change traps
Command: disable snmp rstpport_state_change traps
Success!
DES-1210-28/ME:5#
enable snmp system_device_bootup traps
Purpose To enable SNMP system device bootup traps support on the Switch.
Syntax
enable snmp system_device_bootup traps
Description
The enable snmp system_device_bootup traps command
enables SNMP system device bootup traps support on the Switch.
After enables the SNMP system device bootup traps support, the
Switch will send out a trap to the SNMP manage host when the
device is power on.
Parameters None.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To enable the SNMP system device bootup traps on the Switch:
DES-1210-28/ME:5# enable snmp system_device_bootup traps
Command: enable snmp system_device_bootup traps
Success!
DES-1210-28/ME:5#
disable snmp system_device_bootup traps
Purpose To disable SNMP system device bootup traps support on the Switch.
Syntax
disable snmp system_device_bootup traps
Description
The disable snmp system_device_bootup traps command
disables SNMP system device bootup traps support on the Switch.