D-Link DES-1210-28/ME - Show Address_Binding Auto_Scan List; Enable Address_Binding Dhcp_Snoop; Disable Address_Binding Dhcp_Snoop

DES-1210-28/ME Metro Ethernet Managed Switch CLI Reference Guide
49
show address_binding auto_scan list
Purpose Used to display IP-MAC-port binding entries.
Syntax
show address_binding auto_scan list
Description This command is used to display auto scan list of address binding
on the Switch.
Parameters None.
Restrictions None.
Example usage:
To display the auto scan list of address binding on the Switch:
DES-1210-28/ME:5# show address_binding auto_scan list
Command: show address_binding auto_scan list
VLAN IP Address MAC Address Port Bound
---- --------------- ----------------- ---- -----
DES-1210-28/ME:5#
enable address_binding dhcp_snoop
Purpose Used to enable IP-MAC-port binding DHCP Snooping.
Syntax
enable address_binding dhcp_snoop ports [<portlist> | all]
Description This command is used to enable IP-MAC-port binding DHCP
snooping entries.
Parameters
[<portlist> | all] – Specifies a port, a range of ports or all ports to be
enabled of the address binding DHCP snooping on the Switch.
Restrictions Only administrator or operate-level users can issue this command.
Example usage:
To enable the DHCP snooping of address binding for port 3~5 on the Switch:
DES-1210-28/ME:5# enable address_binding dhcp_snoop ports 3-5
Command: enable address_binding dhcp_snoop ports 3-5
Success.
DES-1210-28/ME:5#
disable address_binding dhcp_snoop
Purpose Used to disable IP-MAC-port binding DHCP Snooping.
Syntax
disable address_binding dhcp_snoop ports [<portlist> | all]
Description This command is used to disable IP-MAC-port binding DHCP
snooping entries.
Parameters
[<portlist> | all] – Specifies a port, a range of ports or all ports to be
enabled of the address binding DHCP snooping on the Switch.
Restrictions Only administrator or operate-level users can issue this command.