D-Link DES-1210-28/ME - Disable Trusted_Host; Create Trusted_Host; Show Trusted_Host

DES-1210-28/ME Metro Ethernet Managed Switch CLI Reference Guide
65
disable trusted_host
Purpose To enable the trusted host.
Syntax
disable trusted_host
Description
The disable trusted_host command disables the trusted host
feature.
Parameters None.
Restrictions Only administrator or operator level users can issue this command.
Example usage:
To disable the trusted host on the Swtich:
DES-1210-28/ME:5# disable trusted_host
Command: disable trusted_host
Success!
DES-1210-28/ME:5#
create trusted_host
Purpose To create a trusted host.
Syntax
create trusted_host <ipaddr>{network <network_address>}
Description
The create trusted_host command creates a trusted host. The
Switch allows specifying up to 30 IP addresses that are allowed to
manage the Switch via in-band based management software. These
IP addresses must be members of the Management VLAN. If no IP
addresses are specified, then there is nothing to prevent any IP
address from accessing the Switch, provided the user knows the
Username and Password.
Parameters
<ipaddr> − The IP address of the trusted host to be created.
<network_address> − The subnet mask of the trusted host to be
created. This parameter is optional. If not specified, the default
subnet mask is 255.255.255.0.
Restrictions Only administrator or operator level users can issue this command.
Example usage:
To create the trusted host:
DES-1210-28/ME:5# create trusted_host 10.90.90.91
Command: create trusted_host 10.90.90.91
Success.
DES-1210-28/ME:5#
show trusted_host
Purpose To display a list of trusted hosts entered on the Switch using the
create trusted_host command above.