D-Link DES-1210-28/ME - Config Router_Ports; Config Router_Ports_Forbidden; To Configure Ports as Router Ports; To Deny Ports Becoming Router Ports

DES-1210-28/ME Metro Ethernet Managed Switch CLI Reference Guide
198
Success !
DES-1210-28/ME:5#
config router_ports
Purpose To configure ports as router ports.
Syntax
config router_ports [vlan_name <string 20> | vlanid <vidlist> |
all] [add | delete] <portlist>
Description
The config router_ports command designates a range of ports as
being connected to multicast-enabled routers. This ensures all
packets with such a router as its destination will reach the multicast-
enabled router − regardless of protocol, etc.
Parameters
vlan_name <string 20> − The name of the VLAN on which the router
port resides. Up to 20 characters can be used.
vlanid <vidlist> − The VLAN id of the VLAN on which the router port
resides.
all − Specifies all ports on the Switch to be configured.
[add | delete] – Specifies whether to add or delete ports defined in
the following parameter <portlist>, to the router port function.
<portlist> − A port or range of ports that will be configured as router
ports.
Restrictions Only administrator or operator-level users can issue this command.
Example usage:
To delete the static router port:
DES-1210-28/ME:5# config router_ports vlanid 2 delete 2
Command: config router_ports vlanid 2 delete 2
Success !
DES-1210-28/ME:5#
config router_ports_forbidden
Purpose To deny ports becoming router ports.
Syntax
config router_ports_forbidden [vlan_name <string 20> | vlanid
<vidlist> | all] [add | delete] <portlist>
Description
The config router_port_forbidden command denies a range of
ports access to multicast–enabled routers. This ensures all packets
with such a router as its destination will not reach the multicast–
enabled router − regardless of protocol, etc.
Parameters
vlan_name <string 20> − The name of the VLAN on which the router
port resides. Up to 20 characters can be used.
vlanid <vidlist> − The VLAN id of the VLAN on which the router port
resides.
all − Specifies all ports on the Switch to be configured.
[add | delete] – Specifies whether to deny ports defined in the
following parameter <portlist>, to the router port function.
<portlist> − A port or range of ports that will be denied access as
router ports.