DES-1210-28/ME Metro Ethernet Managed Switch CLI Reference Guide
61
delete snmp group
Purpose To remove an SNMP group from the Switch.
Syntax
delete snmp group <groupname 32> [v1 | v2c | v3 [auth_priv |
noauth_nopriv]]
Description
The delete snmp group command removes an SNMP group from
the Switch.
Parameters
<groupname 32> − A string of that identifies the SNMP group the
new SNMP user will be associated with. Up to 32 alphanumeric
characters.
Restrictions Only administrator or operate-level users can issue this command.
Example usage:
To delete the SNMP group named ‘sg1’:
DES-1210-28/ME:5# delete snmp group sg1 v3 auth_priv
Command: delete snmp group sg1 v3 auth_priv
Success!
DES-1210-28/ME:5#
show snmp global state
Purpose To display the global state of SNMP currently configured on the
Switch.
Syntax
show snmp global state
Description
The show snmp global state command displays the global state of
SNMP groups currently configured on the Switch.
Parameters None.
Restrictions None.
Example usage:
To display the currently configured SNMP global state on the Switch:
DES-1210-28/ME:5# show snmp global state
Command: show snmp global state
SNMP Global State : Enable
DES-1210-28/ME:5#
show snmp groups
Purpose To display the group-names of SNMP groups currently configured
on the Switch. The security model, level, and status of each group
are also displayed.
To Next Page
Loading...
