D-Link DES-1210-28/ME - Config Lldp Tx_Delay; Show Lldp

DES-1210-28/ME Metro Ethernet Managed Switch CLI Reference Guide
276
config lldp tx_delay
Purpose To configure the lldp tx_delay on the switch.
Syntax
config lldp tx_delay <sec 1-8192>
Description
The config lldp tx_delay command specifies the delay between
successive LLDP frame transmissions initiated by value/status
changes in the LLDP local systems MIB, use the lldp tx_delay
command in global configuration mode.
Parameters
<sec 1-8192> – Specifies the minimum time in seconds an LLDP
port will wait before reinitializing LLDP transmission. The range is
1 – 8192 seconds. The default configuration is 2 seconds.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To configure LLDP tx delay:
DES-1210-28/ME:5# config lldp tx_delay 1
Command: config lldp tx_delay 1
Success!
DES-1210-28/ME:5#
show lldp
Purpose
To display the Link Layer Discovery Protocol (LLDP) on the switch.
Syntax
show lldp
Description
The show lldp displays the LLDP configuration on the switch.
Parameters None.
Restrictions None.
Example usage:
To show LLDP settings: