D-Link DES-1210-28/ME - Dhcp Relay Commands; Enable Dhcp_Relay

DES-1210-28/ME Metro Ethernet Managed Switch CLI Reference Guide
82
15
1515
15
DHCP RELAY COMMANDS
The DHCP Relay commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command Parameter
enable dhcp_relay
disable dhcp_relay
config dhcp_relay add
ipif system
<ipaddr>
config dhcp_relay
delete ipif system
<ipaddr>
config dhcp_relay hops <value 1-16>
config dhcp_relay
option_82
[check [enable | disable] | policy [drop | keep | replace] | remote_id [default |
user_define <string 32>] | state [enable | disable]]
show dhcp_relay {ipif}
enable
dhcp_local_relay
disable
dhcp_local_relay
config dhcp_local_relay
vlan
<vlan_name> | vlanid <vidlist>] state[enable | disable]
show dhcp_local_relay
Each command is listed in detail, as follows:
enable dhcp_relay
Purpose To enable DHCP Relay server on the Switch
Syntax
enable dhcp_relay
Description
The enable dhcp_relay command sets the DHCP Relay to be
globally enabled on the Switch and on all existing VLANs.
Parameters None.
Restrictions Only Administrator or operate-level users can issue this command.
Example usage:
To enable DCHP Relay on the Switch:
DES-1210-28/ME:5# enable dhcp_relay
Command: enable dhcp_relay
Success!