D-Link DES-1210-28/ME - Config Arp_Aging Time; Clear Arptable

DES-1210-28/ME Metro Ethernet Managed Switch CLI Reference Guide
236
config arp_aging time
Purpose To configure the age-out timer for ARP table entries on the Switch.
Syntax
config arp_aging time <value 0-65535 >
Description
The config arp_aging time command sets the maximum amount of
time, in minutes, that an ARP entry can remain in the Switch’s ARP
table, without being accessed, before it is dropped from the table.
Parameters
time <value 0-65535> – The ARP age-out time, in minutes. The
value may be in the range of 0-65535 minutes, with a default setting
of 20 minutes.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To configure ARP aging time:
DES-1210-28/ME:5# config arp_aging time 30
Command: config arp_aging time 30
Success.
DES-1210-28/ME:5#
clear arptable
Purpose To remove all dynamic ARP table entries.
Syntax
clear arptable
Description
The clear arptable command is used to remove dynamic ARP table
entries from the Switch’s ARP table. Static ARP table entries are not
affected.
Parameters None.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To remove dynamic entries in the ARP table:
DES-1210-28/ME:5# clear arptable
Command: clear arptable
Success.
DES-1210-28/ME:5#