D-Link DES-1210-28/ME - Access Control List Commands

DES-1210-28/ME Metro Ethernet Managed Switch CLI Reference Guide
273
42
4242
42
LLDP COMMANDS
The LLDP commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command Parameter
enable lldp
disable lldp
config lldp
message_tx_interval
<sec 5-32768>
config lldp
message_tx_hold_multiplier
<int 2-10>
config lldp reinit_delay <sec 1-10>
config lldp tx_delay <sec 1-8192>
show lldp
show lldp ports {<portlist>}
show lldp local_ports {<portlist>} {mode[brief | normal | detailed]}
show lldp remote_ports {<portlist>} {mode[brief | normal | detailed]}
config lldp ports [<portlist> | all] notification [enable | disable]
config lldp ports [<portlist> | all] admin_status [tx_only | rx_only | tx_and_rx | disable]
config lldp ports [<portlist>|all] mgt_addr ipv4 <ipaddr> [enable | disable]
config lldp ports
[<portlist>|all] basic_tlvs [all | {port_description | system_name |
system_description | system_capabilities}] [enable | disable]
config lldp ports ports
[<portlist>|all] dot3_tlvs [all | link aggregation | mac_phy_configuration_status
| maximum_frame_size | power_via_mdi] [enable | disable]
config lldp ports ports [<portlist>|all] dot1_tlv_pvid [disable | enable]
config lldp ports ports
[<portlist>|all] dot1_tlv_protocol_identity [all | eapol | gvrp | lacp | stp][disable
| enable]
config lldp ports ports
[<portlist>|all] dot1_tlv_vlan_name [vlan <vlan_name 32> | vlanid <vidlist>]
[disable | enable]
show lldp mgt_addr {ipv4 <ipaddr>}
show lldp statistics {ports <portlist>}
Each command is listed in detail, as follows:
enable lldp
Purpose To enable LLDP on the switch.
Syntax
enable lldp