D-Link DES-1210-28/ME - RMON Commands; Enable RMON

DES-1210-28/ME Metro Ethernet Managed Switch CLI Reference Guide
137
Command: show cos mapping port 1-5
Port Port_Priority Ethernet_Priority IP_Priority
-------------------------------------------------------
1 off 802.1p DSCP
2 off 802.1p DSCP
3 off 802.1p DSCP
4 off 802.1p DSCP
5 off 802.1p DSCP
DES-1210-28/ME:5#
config cos protocol_mapping
Purpose To configure the CoS protocol mapping method on the Switch.
Syntax
config cos protocol_mapping protocol <ip_protocol 1-255>
class <class_id 0-3>
Description
The config cos protocol_mapping command is used to configure
the CoS protocol mapping method on the Switch.
Parameters
<ip_protocol 1-255> - Specifies the protocol IP to be mapped.
<class_id 0-3> - Specifies the number of the Switch’s hardware
priority queue
Restrictions Only administrator or operator-level users can issue this command.
Example usage:
To configure the CoS mapping on the Switch:
DES-1210-28/ME:5# config cos protocol_mapping protocol 10 class 1
Command: config cos protocol_mapping protocol 10 class 1
Success!
DES-1210-28/ME:5#
show cos protocol_mapping
Purpose To display the CoS protocol mapping information between an
incoming packet’s 802.1p priority value.
Syntax
show cos protocol_mapping {protocol <ip_protocol 1-255>}
Description
The show cos protocol_mapping command is used to display the
CoS protocol mapping information between an incoming packet’s
802.1p priority value.
Parameters
<ip_protocol 1-255> - Specifies the mapped protocol IP to be
displayed.
Restrictions None.
Example usage:
To display the CoS protocol mapping on the Switch: