D-Link DES-1210-28/ME - Show Lldp Local_Ports

DES-1210-28/ME Metro Ethernet Managed Switch CLI Reference Guide
278
DES-1210-28/ME:5# show lldp ports 1
Port ID : 1
------------------------------------------------------------------
Admin Status : TX_and_RX
Notification Status : Disable
Advertised TLVs Option :
Port Description Disable
Port Description Disable
Port Description Disable
Port Description Disable
Enabled Management Address
(NONE)
Port VLAN ID Disable
Enabled Port_and_Protocol_VLAN_ID
(None)
Enabled VLAN Name
(None)
Enabled Protocol_Identity
(None)
MAC/PHY Configuration/Status Disable
Power Via MDI Disable
Link Aggregation Disable
Maximum Frame Size Disable
DES-1210-28/ME:5#
show lldp local_ports
Purpose
To display the Link Layer Discovery Protocol (LLDP) configuration
that is advertised from a specific port.
Syntax
show lldp local_ports {<portlist>} {mode[brief | normal |
detailed]}
Description
The show lldp local_ports command displays the configuration that
is advertised from a specific port.
Parameters
<portlist> − A port or range of ports to be displayed.
{mode[brief | normal | detailed]} − defines which mode of information
want to be displayed, brief, normal or detailed.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To show the local port information for port 1 with mode brief:
DES-1210-28/ME:5# show lldp local_ports 1 mode brief
Command: show lldp local_ports 1 mode brief
Port ID : 1
---------------------------------------------
Port ID Subtype : Interface Alias
Port ID : Slot0/1
Port ID Desctiption : Ethernet Interface
DES-1210-28/ME:5#