D-Link DES-1210-28/ME - Show Loopdetect

DES-1210-28/ME Metro Ethernet Managed Switch CLI Reference Guide
33
Example usage:
To configure the loop back detection with interval time 500 on the Switch:
DES-1210-28/ME:5# config loopdetect interval_time 500
Command: config loopdetect interval_time 500
Success!
DES-1210-28/ME:5#
show loopdetect
Purpose To display the loop back detection information on the Switch.
Syntax
show loopdetect {ports [<portlist> | all]}
Description
The show loopdetect command displays the loop back detection
information on the Switch.
Parameters
<portlist> − A port or range of ports to be displayed.
all − All ports settings are to be displayed.
Restrictions None.
Example usage:
To display the loop back detection information on the Switch:
DES-1210-28/ME:5# show loopdetect
Command: show loopdetect
Loopdetect Global Settings
----------------------------------
Loopdetect Status : Enabled
Loopdetect Mode : Port-Base
Loopdetect Interval : 100
Recover Time : 60
DES-1210-28/ME:5#