D-Link DES-1210-28/ME - Create Cpu_Access_Profile

DES-1210-28/ME Metro Ethernet Managed Switch CLI Reference Guide
291
configured access profiles.
Parameters
profile_id <value 1-50> – Specifies the access profile to be
displayed. This value is assigned to the access profile when it is
created with the create access_profile command. If the profile_id
parameter is omitted, all access profile entries are displayed.
Restrictions None.
Example usage:
To display the currently configured access profiles which profile id is 1 on the Switch:
DES-1210-28/ME:5# show access_profile profile_id 1
Command: show access_profile profile_id 1
Access Profile Table
Access Profile ID: 1 Type: Ethernet
---------------------------------------------------------------------------
---------------------------------------------------------------------------
Mask Option:
VLAN 802.1p
---------------------------------------------------------------------------
DES-1210-28/ME:5#
create cpu_access_profile
Purpose To create an access profile on the Switch by examining the Ethernet
part of the packet header. Masks entered are combined with the
values the Switch finds in the specified frame header fields. Specific
values for the rules are entered using the config access_profile
command, below.
Syntax
create cpu_access_profile [ ethernet {vlan | source_mac
<macmask> | destination_mac <macmask> | 802.1p |
ethernet_type} | ip {source_ip_mask <netmask> |
destination_ip_mask <netmask> | dscp | [ icmp {type | code} |
igmp {type} | tcp {src_port_mask <hex (0x0-0xffff)> |
dst_port_mask <hex (0x0-0xffff)> | flag_mask} | udp
{src_port_mask <hex (0x0-0xffff)> | dst_port_mask <hex (0x0-
0xffff)>} | protocol_id_mask <hex (0x0-0xff)>] } ] profile_id
<value (1-3)>
Description
The create cpu_access_profile command is used to create CPU
access list rules on the Switch.
Parameters
ethernet - Specifies that the Switch examines the layer 2 part of
each packet header with emphasis on one or more of the following:
• vlan – Specifies a VLAN mask.
• source_mac <macmask > – Specifies the source MAC
mask.
• destination_mac <macmask> – Specifies the destination
MAC mask.
• 802.1p – Specifies 802.1p priority tag mask.