D-Link DES-1210-28/ME - Config Qinq Ports; Create Vlan_Translation

DES-1210-28/ME Metro Ethernet Managed Switch CLI Reference Guide
173
DES-1210-28/ME:5#
config qinq ports
Purpose Used to configure Q-in-Q ports.
Syntax
config qinq ports [<portlist> | all] {role [nni | uni] | outer_tpid
<hex 0x1 - 0xffff> | trust_cvid [enable | disable] |
vlan_translation [enable | disable] }
Description
The config qinq ports command is used to configure the port level
setting for the Q-in-Q VLAN function. This setting is not effective
when the Q-in-Q mode is disabled.
Parameters
<portlist> - A range of ports to configure.
all – Specifies all ports to be configure.
role - Port role in Q-in-Q mode, it can be UNI port or NNI port.
outer_tpid - TPID in the SP-VLAN tag.
trust_cvid - For C-Tag packets, trust C-VID determines if S-VID is
enabled. Otherwise, the default is disabled.
vlan_translation - If specified as enabled, the VLAN translation will
be performed on the port. The setting is disabled by default.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure port list 1 to 4 as NNI port, set outer TPID to 0x88a8:
DES-1210-28/ME:5# config qinq ports 1-4 role nni outer_tpid 0x88a8
Command: config qinq ports 1-4 role nni outer_tpid 0x88a8
Warning: The outer TPID will be globally applied to all ports!
Success!
DES-1210-28/ME:5#
create vlan_translation
Purpose To create a VLAN translation rule that will be added as a new rule or
replace a current rule.
Syntax
create vlan_translation [add | replace] cvid <vidlist> svid
<vlanid 1-4094>
Description
The create vlan_translation cvid command is used to create a
VLAN translation rule to add to or replace the outgoing packet which
is single S-tagged (the C-VID changes to S-VID and the packet’s
TPID changes to an outer TPID).
Parameters
cvid – C-VLAN ID of packets that ingress from a UNI port.
svid – The S-VLAN ID that replaces the C-VLAN ID or is inserted in
the packet.
<vlanid 1-4094> – A VLAN ID between 1 and 4094.
Restrictions None.
Example usage: