D-Link DES-1210-28/ME - Config Stp Priority; Enable Stp; Disable Stp

DES-1210-28/ME Metro Ethernet Managed Switch CLI Reference Guide
110
config stp priority
Purpose To update the STP instance configuration.
Syntax
config stp priority <value 0-61440> instance_id <value 0-15>
Description
The config stp priority command updates the STP instance
configuration settings on the Switch. The MSTP uses the priority in
selecting the root bridge, root port and designated port. Assigning
higher priorities to STP regions instructs the Switch to give
precedence to the selected instance_id for forwarding packets. A
lower value indicates a higher priority.
Parameters
priority <value 0-61440> - The priority for a specified instance_id for
forwarding packets. The value may be between 0 and 61440, and
must be divisible by 4096. A lower value indicates a higher priority.
instance_id <value 0-15> - The value of the previously configured
instance id for which the user wishes to set the priority value. An
instance_id of 0 denotes the default instance_id (CIST) internally set
on the Switch.
Restrictions Only administrator or operator-level users can issue this command.
Example usage:
To set the priority value for instance_id 2 as 4096:
DES-1210-28/ME:5# config stp priority 4096 instance_id 2
Command: config stp priority 4096 instance_id 2
Success.
DES-1210-28/ME:5#
enable stp
Purpose To globally enable STP on the Switch.
Syntax
enable stp
Description
The enable stp command sets the Spanning Tree Protocol to be
globally enabled on the Switch.
Parameters None.
Restrictions Only administrator or operator-level users can issue this command.
Example usage:
To enable STP, globally, on the Switch:
DES-1210-28/ME:5# enable stp
Command: enable stp
Success.
DES-1210-28/ME:5#
disable stp
Purpose To globally disable STP on the Switch.
Syntax
disable stp