D-Link DES-1210-28/ME - Qos Commands

DES-1210-28/ME Metro Ethernet Managed Switch CLI Reference Guide
129
21
2121
21
QOS COMMANDS
The QoS commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command Parameter
config scheduling <class_id 0-3> weight <value 0-55>
show scheduling
config
bandwidth_control
[<portlist> | all] {rx_rate [no_limit | <value 64-1024000>] | tx_rate [no_limit |
<value 64-1024000>]}
show
bandwidth_control
[<portlist> | all]
config cos
mac_mapping
destination_addr <macaddr> class <class_id 0-3>
show cos
mac_mapping
{destination_addr <macaddr>}
delete cos
mac_mapping
destination_addr <macaddr>
config cos ip_mapping destination_ip <ipaddr> class <class_id 0-3>
show cos ip_mapping {destination_ip <ipaddr>}
delete cos ip_mapping destination_ip <ipaddr>
config cos mapping port [<portlist> | all] [802.1p | dscp_tos | none]
show cos mapping {port <portlist>}
config cos
protocol_mapping
protocol <ip_protocol 1-255> class <class_id 0-3>
show cos
protocol_mapping
{protocol <ip_protocol 1-255>}
delete cos
protocol_mapping
protocol <ip_protocol 1-255>
config cos
vlanid_mapping
vid <vlanid 1-4094> class <class_id 0-3>
show cos
vlanid_mapping
{vid <vlanid 1-4094>}
delete cos
vlanid_mapping
vid <vlanid 1-4094>
config cos tos value <value 0-7> class <class_id 0-3>
show cos tos {value <value 0-7>}
config cos
tcp_port_mapping
destination_port <value 0-65535> class <class_id 0-3>
show cos
{destination_port <value 0-65535>}