D-Link DES-1210-28/ME - Basic Switch Commands; Enable Password Encryption

DES-1210-28/ME Metro Ethernet Managed Switch CLI Reference Guide
10
4
44
4
BASIC SWITCH COMMANDS
The Basic Switch commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command Parameter
enable password
encryption
disable password
encryption
create account [admin | operator | user] <username 15>
config account <username 15>
show account
delete account <username 15>
show session
show switch
enable web <tcp_port_number 1-65535>
disable web
enable autoconfig
disable autoconfig
save {[config config_id <value 1-2> | log | account]}
reboot
reset {[config | system | account | password]} {force_agree}
logout
ping <ipaddr> {times <value 1-255>} {timeout <sec 1-99>}
enable telnet
disable telnet
show tech support
Each command is listed in detail, as follows:
enable password encryption
Purpose Used to enable password encryption on a user account.
Syntax
enable password encryption
Description The user account configuration information will be stored in the
configuration file, and can be applied to the system at a time in the
future. If the password encryption is enabled, the password will be in
encrypted form. If password encryption is disabled and the user
specifies the password in encrypted form, or if the password has