D-Link DES-1210-28/ME - Show Snmp Host; Enable Trusted_Host

DES-1210-28/ME Metro Ethernet Managed Switch CLI Reference Guide
64
show snmp host
Purpose To display the recipient of SNMP traps generated by the Switch’s
SNMP agent.
Syntax
show snmp host {<ipaddr>}
Description
The show snmp host command is used to display the IP addresses
and configuration information of remote SNMP managers that are
designated as recipients of SNMP traps generated by the Switch’s
SNMP agent.
Parameters
<ipaddr> − The IP address of a remote SNMP manager that
receives SNMP traps generated by the Switch’s SNMP agent.
Restrictions None.
Example usage:
To display the currently configured SNMP hosts on the Switch:
DES-1210-28/ME:5# show snmp host
Command: show snmp host
SNMP Host Table
(Maximum Entries : 10)
Host IP Address SNMP Version Community Name/SNMPv3 User Name
------------------------ --------------------- -------------------------------------------------------
10.90.90.22 V3-NoAuthNoPriv dlink
Total Entries : 1
DES-1210-28/ME:5#
enable trusted_host
Purpose To enable the trusted host.
Syntax
enable trusted_host
Description
The enable trusted_host command enables the trusted host
feature.
Parameters None.
Restrictions Only administrator or operator level users can issue this command.
Example usage:
To enable the trusted host on the Swtich:
DES-1210-28/ME:5# enable trusted_host
Command: enable trusted_host
Success!
DES-1210-28/ME:5#