DES-1210-28/ME Metro Ethernet Managed Switch CLI Reference Guide
21
Command: enable telnet
Success.
DES-1210-28/ME:5#
disable telnet
Purpose To disable telnet.
Syntax
disable telnet
Description
The disable telnet command disables telnet.
Parameters None.
Restrictions Only Administrator or operate-level users can issue this command
Example usage:
To disable telnet:
DES-1210-28/ME:5# disable telnet
Command: disable telnet
Success.
DES-1210-28/ME:5#
show tech support
Purpose To display system and configuration information. to provide to the
Technical Assistance Center when reporting a problem, use the
show tech-support command.
Syntax
show tech support
Description
The show tech support command displays system and
configuration information. to provide to the Technical Assistance
Center when reporting a problem.
By default, this command displays the output for technical-support-
related show commands. Use keywords to specify the type of
information to be displayed. If you do not specify any parameters,
the system displays all configuration and memory data.
The show tech support command may time out if the configuration
file output takes longer to display than the configured session
timeout time. If this happens, enter a set logout timeout value of 0 to
disable automatic disconnection of idle sessions or enter a longer
timeout value.
The show tech support command output is continuous; it does not
display one screen at a time. To interrupt the output, press Esc.
Parameters None.
Restrictions Only Administrator-level users can issue this command..
Example usage:
To display technical support information on the Switch:
DES-1210-28/ME:5# show tech support
To Next Page
Loading...
