D-Link DES-1210-28/ME - Config Access_Profile

DES-1210-28/ME Metro Ethernet Managed Switch CLI Reference Guide
287
TCP) for the action to take place.
• src_port_mask <hex 0x0-0xffff> – Specifies a TCP port
mask for the source port.
• dst_port_mask <hex 0x0-0xffff> – Specifies a TCP port
mask for the destination port.
• flag_mask – Specifies the appropriate flag_mask
parameter.
udp – Specifies that the Switch examines each frame’s protocol
field and it’s value must be 17 (User Datagram Protocol-UDP) in
order for the action to take place..
• src_port_mask <hex 0x0-0xffff> – Specifies a UDP port
mask for the source port.
• dst_port_mask <hex 0x0-0xffff> – Specifies a UDP port
mask for the destination port.
packet_content_mask – Specifies the frame content mask.
[offset1 | offset2 | offset3 | offset4] – Specifies the mask pattern
offset of frame.
profile_id <value 1-50> – Specifies an index number between 1 and
50 that identifies the access profile being created with this
command.
Restrictions Only administrator or operate-level users can issue this command.
Example usage:
To create an Ethernet access profile:
DES-1210-28/ME:5# create access_profile ethernet vlan 802.1p profile_id 1
Command: create access_profile ethernet vlan 802.1p profile_id 1
Success.
DES-1210-28/ME:5#
config access_profile
Purpose To create an access profile on the Switch by examining the Ethernet
part of the packet header. Masks entered are combined with the
values the Switch finds in the specified frame header fields. Specific
values for the rules are entered using the config access_profile
ethernet command, below.
Syntax
config access_profile [profile_id <value (1-50)>] [add access_id
[auto_assign | <value (1-250)>]] [ ethernet {vlan <vlanid (1-
4094)> | source_mac <macaddr> | destination_mac <macaddr> |
802.1p <value (0-7)> | ethernet_type <hex (0x0-0xffff)>} | ip
{source_ip <ipaddr> | destination_ip <ipaddr> | dscp <value (0-
63)> | [icmp {type <value (0-255)> code <value (0-255)>} | igmp
{type <value (0-255)>} | tcp {src_port <value (0-65535)> |
dst_port <value (0-65535)> | urg | ack | psh | rst | syn | fin} | udp
{src_port <value (0-65535)> | dst_port <value (0-65535)>} |
protocol_id <value(0-255)>]} | packet_content {offset1 <hex
(0x0-0xffffffff)> | offset2 <hex (0x0-0xffffffff)> | offset3 <hex (0x0-
0xffffffff)> | offset4 <hex (0x0-0xffffffff)>}] [port [<portlist> | all]
[permit {replace_priority_with <value (0-7)> | replace_dscp_with
<value (0-63)> | rx_rate {no_limit | <value (64-1024000)>}} |
mirror | deny]] delete access_id <value (1-250)>]