D-Link DES-1210-28/ME - Config Cos Tos; Show Cos Tos

DES-1210-28/ME Metro Ethernet Managed Switch CLI Reference Guide
140
DES-1210-28/ME:5#
config cos tos
Purpose To configure the CoS tos on the Switch.
Syntax
config cos tos value <value 0-7> class <class_id 0-3>
Description
The config cos tos command is used to configure the CoS tos on
the Switch.
Parameters
<value 0-7> - Specifies the value of the Switch’s tos queue.
<class_id 0-3> - Specifies the number of the Switch’s hardware
priority queue.
Restrictions Only administrator or operator-level users can issue this command.
Example usage:
To configure a CoS tos on the Switch:
DES-1210-28/ME:5# config cos tos value 1 class 1
Command: config cos tos value 1 class 1
Success
DES-1210-28/ME:5#
show cos tos
Purpose To display the CoS tos mapping information between an incoming
packet’s 802.1p priority value.
Syntax
show cos tos {value <value 0-7>}
Description
The show cos tos command is used to display the CoS tos
mapping information.
Parameters
<value 0-7> - Specifies the value of the Switch’s tos queue.
Restrictions None.
Example usage:
To display the CoS tos mapping on the Switch:
DES-1210-28/ME:5# show cos tos
Command: show cos tos
TOS Class
-------------
0 0
1 1
2 0
3 0
4 0
5 0