The copy operation was completed successfully
!
3920460 bytes copied in 00:03:01 [hh:mm:ss]
DES-1210-28/ME:5#
To download a configuration file:
DES-1210-28/ME:5# download configuration 10.48.74.121 c:\cfg\setting.txt
Overwrite file [startup-config] ?[Yes/press any key for no]....
01-Jan-200003:19:46%COPY-I-FILECPY:FilesCopy-source URL tftp://10.48.74.121/1.txt
destination
URL flash://startup-config
Success.
Success.
.....01-Jan-2000 03:18:40 %COPY-N-TRAP: The copy operation was completed
successfully!
Copy: 267 bytes copied in 00:00:08 [hh:mm:ss]
DES-1210-28/ME:5#
upload
Purpose To upload the current switch settings to a TFTP server.
Syntax
upload [
[firmw
are <ipaddr> <pat
h_filen
ame 64>] | [
cfg_to
TFTP
<ipaddr>
<path_filen
ame 64> co
nfig_id
<value 1-2
>] |
[log_to
TFTP <ipad
dr> <path
_filename
64>]]
Description
The upload command uploads the Switch’s current settings to a
TFTP server.
Parameters
firmware − Specifies that the Switch’s current firmware are to be
uploaded to the TFTP server.
<ipaddr> − The IP address of the TFTP server. The TFTP server
must be on the same IP subnet as the Switch.
<path_filename 64> − The location of the Switch configuration file on
the TFTP server.
config_id <value 1-2> − Specifies the config id which to be
uploaded.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
DES-1210-28/ME:5# upload log_toTFTP 1.1.1.23 des-1210-28me.ros
Command: upload log_toTFTP 1.1.1.23 des-1210-28me.ros
01–Jan–2000 01:26:11 %COPY–I–FILECPY: Files Copy – source
URL running–config destination URL tftp://1.1.1.23/1\running–
To Next Page
Loading...
