D-Link DES-1210-28/ME - Page 292

DES-1210-28/ME Metro Ethernet Managed Switch CLI Reference Guide
280
Description
The config lldp ports admin status command defines lldp admin
status per port on the switch.
Parameters
[<portlist> | all] – Specify a port or ports to be configured.
Admin status – defines admin status of ports on the switch
Tx- Tx only
Rx – Rx only
Both – Tx and RX
Disable – admin status disabled.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To configure LLDP admin status
DES-1210-28/ME:5# config lldp ports 2 admin_status disable
Command: config lldp ports 2 admin_status disable
Success!
DES-1210-28/ME:5#
config lldp ports
Purpose To define LLDP management address advertisement on a port or
ports.
Syntax
config lldp ports [<portlist>|all] mgt_addr ipv4 <ipaddr> [enable
| disable]
Description
The config lldp mgt_addr command defines if lldp will advertise the
switch’s IP address the command is per port on the switch.
Parameters
[<portlist> | all] – Specify a port or ports to be configured.
mgt_addr ipv4 <ipaddr> – defines wether the management address
(IP address) advertisement will be enabled or disabled
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To configure LLDP management address advertisement
DES-1210-28/ME:5# config lldp ports 1 mgt_addr ipv4 100.1.1.2 enabled
Command: config lldp ports 1 mgt_addr ipv4 100.1.1.2 enabled
Success!
DES-1210-28/ME:5#
config lldp ports
Purpose To define LLDP management basic TLVs advertisement on a port or
ports.
Syntax
config lldp ports [<portlist>|all] basic_tlvs [all |
{port_description | system_name | system_description |
system_capabilities}] [enable | disable]
Description
The config lldp basic TLVs command defines if lldp will advertise