D-Link DGS-3000 - Page 108

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
104
end_time - Specify the ending time of a day. (24-hr time)
<time hh:mm:ss> - Enter the ending time here. (24-hr time). For example, 19:00 means
7PM. 19 is also acceptable. The time specified in the start_time parameter must be
smaller than the time specified in the end_time parameter.
weekdays - Specify the list of days contained in the time range. Use a dash to define a period of
days. Use a comma to separate specific days.
<daylist> - Enter the weekdays that will be included in this configuration here. For example,
mon-fri (Monday to Friday). sun, mon, fri (Sunday, Monday and Friday)
delete - Deletes a time range profile. When a time_range profile has been associated with ACL
entries, deleting the time_range profile will fail.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure a time range named “1” that starts every Monday at 01:01:01am and ends at
02:02:02am:
DGS-3000-26TC:admin#config time_range 1 hours start_time 1:1:1 end_time 2:2:2
weekdays mon
Command: config time_range 1 hours start_time 1:1:1 end_time 2:2:2 weekdays mon
Success.
DGS-3000-26TC:admin#config time_range 1 delete
Command: config time_range 1 delete
Success.
DGS-3000-26TC:admin#
show time_range 6-8
Description
This command is used to display the current time range settings.
Format
show time_range
Parameters
None.
Restrictions
None.