DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
415
Chapter 39
IP-MAC-Port Binding (IMPB)
Command List
create address_binding ip_mac ipaddress <ipaddr> mac_address <macaddr> {ports [<portlist> |
all]}
config address_binding ip_mac ports [<portlist> | all] {arp_inspection [strict | loose | disable] |
ip_inspection [enable | disable] | protocol [ipv4 | ipv6 | all] | allow_zeroip [enable | disable] |
forward_dhcppkt [enable | disable] | stop_learning_threshold <int 0-500>}
create address_binding ip_mac ipv6address <ipv6addr> mac_address <macaddr> {ports
[ <portlist>| all]}
config address_binding ip_mac ipv6address <ipv6addr> mac_address <macaddr> {ports
[<portlist>| all]}
delete address_binding blocked [all | vlan_name <vlan_name> mac_address <macaddr>]
delete address_binding ip_mac [all | ipaddress <ipaddr> mac_address <macaddr> | ipv6address
<ipv6addr> mac_address <macaddr>]
config address_binding ip_mac ipaddress <ipaddr> mac_address <macaddr> {ports [<portlist>
| all]}
show address_binding {ports {<portlist>}}
show address_binding blocked [all | vlan_name <vlan_name> mac_address <macaddr>]
show address_binding ip_mac [all | [[ipaddress <ipaddr> | ipv6address <ipv6addr>]
{mac_address <macaddr>}| mac_address <macaddr>]]
enable address_binding dhcp_snoop {[ipv6 | all]}
disable address_binding dhcp_snoop {[ipv6 | all]}
clear address_binding dhcp_snoop binding_entry ports [<portlist> | all] {[ipv6 | all]}
show address_binding dhcp_snoop {max_entry {ports <portlist>}}
show address_binding dhcp_snoop binding_entry {port <port>}
config address_binding dhcp_snoop max_entry ports [<portlist> | all] limit [<value 1-50> |
no_limit] {ipv6}
enable address_binding nd_snoop
disable address_binding nd_snoop
config address_binding nd_snoop ports [<portlist> | all] max_entry [<value 1-50> | no_limit]
show address_binding nd_snoop {ports <portlist>}
show address_binding nd_snoop binding_entry {port <port>}
clear address_binding nd_snoop binding_entry ports [<portlist> | all]
enable address_binding trap_log
disable address_binding trap_log
config address_binding recover_learning ports [<portlist> | all]
debug address_binding [event | dhcp | all] state [enable | disable]
enable address_binding roaming
disable address_binding roaming
create address_binding ip_mac 39-1
Description
This command is used to create an IMPB entry.
To Next Page
Loading...
