DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
416
Format
create address_binding ip_mac ipaddress <ipaddr> mac_address <macaddr> {ports
[<portlist> | all]}
Parameters
ipaddress - Specify the IP address used for the IMPB entry.
<ipaddr> - Enter the IP address used here.
mac_address - Specify the MAC address used for the IMPB entry.
<macaddr> - Enter the MAC address used here.
ports - (Optional) Specify the portlist the entry will apply to. If not ports are specified, the settings
will be applied to all ports.
<portlist> - Enter a list of ports used for this configuration here.
all - Specify that all the ports will be included.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To create an IMPB entry:
DGS-3000-26TC:admin#create address_binding ip_mac ipaddress 10.1.1.1
mac_address 00-00-00-00-00-11
Command: create address_binding ip_mac ipaddress 10.1.1.1 mac_address 00-00-00-
00-00-11
Success.
config address_binding ip_mac ports 39-2
Description
This command is used to configure the state of IMPB on the Switch for each port.
Format
config addr
ess_binding ip_mac por
t
s
[<portlist> | all] {
a
rp_ins
p
ection [str
i
ct | loos
e
|
disable] | ip_inspection [enable | disable] | protocol [ipv4 | ipv6 | all] | allow_zeroip [enable |
disable] | forward_dhcppkt [enable | disable] | stop_learning_threshold <int 0-500>}
Parameters
ports - Specify the ports used for this configuration.
<portlist> - Enter the list of ports used for this configuration here.
all - Specify that all the ports will be used.
arp_inspection - (Optional) Specify that the ARP inspection option will be configured.
strict - In this mode, all packets are dropped by default until a legal ARP or IP packets are
detected.
loose - In this mode, all packets are forwarded by default until an illegal ARP or broadcast IP
To Next Page
Loading...
