D-Link DGS-3000 - Chapter 90 Traffic Segmentation Command List

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
840
Chapter 90 Traffic Segmentation
Command List
config traffic_segmentation [<portlist> | all] forward_list [null | all | <portlist>]
show traffic_segmentation {<portlist>}
config traffic_segmentation 90-1
Description
This command is used to configure the traffic segmentation.
Format
config traffic_segmentation [<portlist> | all] forward_list [null | all | <portlist>]
Parameters
<portlist> - Enter a range of ports to be configured.
all - Specify that all the ports will be used for this configuration.
forward_list - Specify a range of port forwarding domain.
null - Specify a range of port forwarding domain is null.
all - Specify all ports to be configured.
<portlist> - Enter a range of ports to be configured.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure traffic segmentation:
DGS-3000-26TC:admin#config traffic_segmentation 1-10 forward_list 11-15
Command: config traffic_segmentation 1-10 forward_list 11-15
Success.
DGS-3000-26TC:admin#
show traffic_segmentation 90-2
Description
This command is used to display current traffic segmentation table.