D-Link DGS-3000 - Config Cfm Ais MD [<String 22> | Md_Index <Uint 1-4294967295>] Ma [<String 22> | Ma_Index; Disable]

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
166
pdu_priority - The 802.1p priority is set in the CCMs and the LTMs messages transmitted by the
MEP. The default value is 7.
<int 0-7> - Enter the PDU priority value here. This value must be between 0 and 7.
fault_alarm - Specify the control types of the fault alarms sent by the MEP.
all - All types of fault alarms will be sent.
mac_status - Only the fault alarms whose priority is equal to or higher than “Some Remote
MEP MAC Status Errors” are sent.
remote_ccm - Only the fault alarms whose priority is equal to or higher than “Some Remote
MEPs Down” are sent.
error_ccm - Only the fault alarms whose priority is equal to or higher than “Error CCM
Received” are sent.
xcon_ccm - Only the fault alarms whose priority is equal to or higher than “Cross-connect
CCM Received” are sent.
none - No fault alarm is sent. This is the default value.
alarm_time - Specify the time that a defect must exceed before the fault alarm can be sent. The
unit is centisecond, the range is 250-1000. The default value is 250.
<centisecond 250-1000> - Enter the alarm time value here. This value must be between 250
and 1000 centiseconds.
alarm_reset_time - Specify the dormant duration time before a defect is triggered before the
fault can be re-alarmed. The unit is centisecond, the range is 250-1000. The default value is
1000.
<centisecond 250-1000> - Enter the alarm reset time value here. This value must be
between 250 and 1000 centiseconds.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure a CFM MEP:
DGS-3000-26TC:admin#config cfm mep mepname mep1 state enable ccm enable
Command: config cfm mep mepname mep1 state enable ccm enable
Success.
DGS-3000-26TC:admin#
config cfm ais md 16-7
Description
This command is used to configure the parameters of the AIS function on a MEP.
Format
config cfm ais md [<string 22> | md_index <uint 1-4294967295>] ma [<string 22> | ma_index
<uint 1-4294967295>] mepid <int 1-8191> {period [1sec | 1min] | level <int 0-7> | state [enable |
disable]}(1)
Parameters
md - Specify the maintenance domain name.
<string 22> - Enter the maintenance domain name. The maximum length is 22 characters.
md_index - Specify the maintenance domain index.